root
09-28-2013, 04:03 PM
anyone got a good load for the H&H 375 with a cast boolit?
Just got a ruger No. 1 in stainless and before I order a bunch of stuff I wanted the groups collective experience with this 1st.
Gun came with RCBS 2 die set and 25 pcs new Win brass.
near as I can tell on the end of the barrel calipers say 377
so should I size to 377 with this gun or other?
lyman is only listing 375,377,378,379
also any powder loads for the cast pellets
was looking to get the Lee 2-Cavity Bullet Mold 379-250-RF 375 Winchester, 38-55 WCF (379 Diameter) 250 Grain Flat Nose.
Any and all input is welcome.
I
Then if it worked out ok get a RCBS or SACO mold.
Just got a ruger No. 1 in stainless and before I order a bunch of stuff I wanted the groups collective experience with this 1st.
Gun came with RCBS 2 die set and 25 pcs new Win brass.
near as I can tell on the end of the barrel calipers say 377
so should I size to 377 with this gun or other?
lyman is only listing 375,377,378,379
also any powder loads for the cast pellets
was looking to get the Lee 2-Cavity Bullet Mold 379-250-RF 375 Winchester, 38-55 WCF (379 Diameter) 250 Grain Flat Nose.
Any and all input is welcome.
I
Then if it worked out ok get a RCBS or SACO mold.