AlaskanGuy
09-12-2013, 09:06 PM
Hi gang,
I bought a couple new molds, and am trying to work up a load for a modern 308 for the small blacktails we have where i live. Mold i have is a 2 cavity C309-170-F from LEE. It is a 170 gr flat nose 309. I cast a bunch of boolets and quenched them, and installed gas checks when i ran them through the sizer with alox, but i am a bit lost on powder.. I have almost no access to any other powder then I have currently due to availability..I have the following powders available to me...
Hodgdon 4350
IMR 4064
Imr 3031
Alliant 2400
Imr hi-skor 800-x
If there is anybody that can recommend a load based on one of these powders, i would be most greatful. I read a harris article that 3031 would do ok as a starting point with 26 gr of 3031 as a substitute.. But would love to see if one of the cast experts here has a recommendation...
Thanks so much,
AlaskanGuy
I bought a couple new molds, and am trying to work up a load for a modern 308 for the small blacktails we have where i live. Mold i have is a 2 cavity C309-170-F from LEE. It is a 170 gr flat nose 309. I cast a bunch of boolets and quenched them, and installed gas checks when i ran them through the sizer with alox, but i am a bit lost on powder.. I have almost no access to any other powder then I have currently due to availability..I have the following powders available to me...
Hodgdon 4350
IMR 4064
Imr 3031
Alliant 2400
Imr hi-skor 800-x
If there is anybody that can recommend a load based on one of these powders, i would be most greatful. I read a harris article that 3031 would do ok as a starting point with 26 gr of 3031 as a substitute.. But would love to see if one of the cast experts here has a recommendation...
Thanks so much,
AlaskanGuy