rcbs mold spru cutter lube?

[shooter bob]

just got an rcbs mold its the .30-180-fn read the instructions &it does not say anything about lubrication on the sprue cutter .Will the powder graphite that i use on my lyman mold be ok? I also have permatex anti-seize i use on lee molds.Lee says to use anti-seize lyman uses dry graphite.Thinkin its a steel mold so use the graphite.Thanks for any help Bob

[Three-Fifty-Seven]

Shop[/url]

[MtGun44]

Bull Plate lube available from BullShop, a member here, applied very sparingly
works extremely well. It will remove existing lead smears over a casting session
and prevents new lead smears. Also good on mold alignment features.

Bill

[shooter bob]

thanks guys gonna look into bullplate .I have seen bullplate spoken of often on this site so it must be good stuff gonna try it thanks again.I really like this site