skeettx
07-30-2013, 06:58 PM
I ran into a batch of Rem-UMC cases with very small flash holes.
Yes, I know I should sort then out and dispose of them but
that is too much work.
These cases were pulling out the decapping pin from the stem :mad:
So, I bought a spare oil pan drain bolt (1/2x20) drilled and tapped a #10X32 hole.
Shortened the drain bolt a bit, and cut off the flair, then used a Lyman decapping stem
with the headed decapping pin and all is well with the world.
Mike
Yes, I know I should sort then out and dispose of them but
that is too much work.
These cases were pulling out the decapping pin from the stem :mad:
So, I bought a spare oil pan drain bolt (1/2x20) drilled and tapped a #10X32 hole.
Shortened the drain bolt a bit, and cut off the flair, then used a Lyman decapping stem
with the headed decapping pin and all is well with the world.
Mike