303Guy
07-25-2013, 02:41 AM
77080 This is an aluminium boolit holder sitting in a container which holds the molten lube. The boolits (bullets in this case) get picked up and seated directly. The case has a card wad held in place by the powder.
77081 Here I changed tack. The lube was rolled into a ball and placed on the card wad and the heated bullet placed on top. I used the same aluminium heater block in the pick above, just without the lube. The lube 'glues' the bullet in the neck.
No reason it won't work with cast.
77081 Here I changed tack. The lube was rolled into a ball and placed on the card wad and the heated bullet placed on top. I used the same aluminium heater block in the pick above, just without the lube. The lube 'glues' the bullet in the neck.
No reason it won't work with cast.