Lyman 314299 boolit

[beppe]

hello to everyone! lyman the bullets of .314 diameter are too large for the shells s & b. turning I had half a tenth of a millimeter. happened to any of you?


76203


ciao a tutti !
i proiettili lyman di diametro .314 sono troppo grandi per i bossoli s&b .ho dovuto tornire di mezzo decimo di millimetro .A qualcuno di voi è capitato ?

[beppe]

sorry! are too large because the 'bad shutter closes, it takes too much force.

[runfiverun]

that's fairly common.
but is the better solution over having the boolits too small.

[texassako]

I do the same in 7.35 Carcano. It is the only way to fit a properly sized cast round in their tight chambers.

[beppe]

well, I must say that I am so happy! I like to make the shells of the right size ....... with my 6ppc I really enjoy.

:violin:


bene ,devo dire che sono contento cosi !! mi piace fare i bossoli della misura giusta ....... con il mio 6ppc mi diverto molto

[Shiloh]

My old 311299 was to small. I sold it and bought a 314299.

Shiloh

[beppe]

I also have a lyman silhouettes 311 160 grain, I use this for bullets wrapped and run up to 2300 fps, this new bullet 314 I have not tried it as it runs.

anche io ho un lyman siluette 311 da 160 grani , questo lo uso per proiettili incartati e corrono fino a 2300 fps ,questo nuovo proiettile 314 ancora non ho provato quanto corre .

[spfd1903]

Just bought this mold and cast 150 boolits from 20:1 alloy. Not happy with the Lee C312-185-1R in an M44 and 91/30 Mosin, and an Enfield Mk 4. All three rifles border on a .313 groove diameter, the Lee casts are a hair too small. Starting to load the 314299's from the Lyman Cast bullet manual for 2400 and ACC 5744. Hope to have good results.