Tatume
07-14-2013, 11:47 AM
Hi Folks,
Recently I purchased a number of Lee 6-cavity molds. Three of them were for gas check bullets, and I sent them off to be lathe-turned to plain base configuration. Until today I have not had time to try any of them. The Ranch Dog 430-265 has now produced a very large pile of very nice bullets. It took longer than I expected to start dropping nice bullets, but I turned up the heat and then was almost immediately rewarded. To say I'm pleased would be an understatement.
I think I will try them initially as cast with Lee Liquid Alox and relatively mild loads.
Take care, Tom
Recently I purchased a number of Lee 6-cavity molds. Three of them were for gas check bullets, and I sent them off to be lathe-turned to plain base configuration. Until today I have not had time to try any of them. The Ranch Dog 430-265 has now produced a very large pile of very nice bullets. It took longer than I expected to start dropping nice bullets, but I turned up the heat and then was almost immediately rewarded. To say I'm pleased would be an understatement.
I think I will try them initially as cast with Lee Liquid Alox and relatively mild loads.
Take care, Tom