View Full Version : Round ball mold
Sax.45
06-24-2013, 09:30 AM
Is it possible to enlarge a round ball mold? I have a round ball mold .375, Has anyone ever enlarge one a few thousandths? Its a lyman steel mold. I'm thinking I can use an abrasive covered ball. Any help would be appreciated.
Thanks.
The only way I have ever done this is to cut a new cherry and recut the mould. I have never tried lapping a round ball mould but it should work for just 2 or 3 thou.
Catshooter
06-24-2013, 11:45 PM
Sax,
You could Beagle it suppose, never tried it though so I can't say it'd work.
If you watch eBay hard enough you can often find what you need. I waited quite a while to find a .380 round ball and finally did.
Welcome to the site too.
Cat
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.