Jim
06-06-2013, 02:19 PM
I find that I want to see the pointer on my beam scale at the level of the pointer, not from above. So, I built a simple little stand for it. Not only does it not take up bench space, it provides a bit more by getting the scale up off the bench.
72839
The left end has two screws in it. The right end, shown here, has only one. If there's a bit of wobble to the stand, I can twist the right end piece to firm it up.
72840
The top is 4" wide by 18" long. The end pieces are 9" high with a 9" base. It's fairly steady and is working good so far.
I got Janet to switch the colors on the end of the beam pointer. Now my eyes don't play tricks on me.
72850
72839
The left end has two screws in it. The right end, shown here, has only one. If there's a bit of wobble to the stand, I can twist the right end piece to firm it up.
72840
The top is 4" wide by 18" long. The end pieces are 9" high with a 9" base. It's fairly steady and is working good so far.
I got Janet to switch the colors on the end of the beam pointer. Now my eyes don't play tricks on me.
72850