View Full Version : hoch mould
I just got my first hoch mould. Could anyone tell me how much tenson should be on the sprue plate?Right now it will swing open on its own. thinks bill
NoZombies
05-31-2013, 02:11 AM
I just got my first hoch mould. Could anyone tell me how much tenson should be on the sprue plate?Right now it will swing open on its own. thinks bill
That's how mine are. Mine cast better that way.
Von Gruff
05-31-2013, 02:32 AM
Mine does as well. Justfree enough to move of its own accord if the mould is tipped over when cold.
Doc Highwall
05-31-2013, 08:28 AM
All sprue plates should be able to swing freely when the mould is at operating temperature, otherwise they will trap air giving poor bullet fill out.
Thinks for the info. thinks bill
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.