PDA

View Full Version : WFLGC mold


thomashoward
05-23-2013, 11:50 PM
Can someone steer me toward a mold that would produce the wide flat gas check 200gr 10mm bullet sold by double tap.
i would like to have molds for all handguns as, California is on the way toward banning lead bullets
long time lurker,caster, re-loader with a new to me 10mm.
thank you
Hounddog
05-24-2013, 02:58 AM
You can always try these from accurate molds:

http://accuratemolds.com/bullet_detail.php?bullet=40-200A-D.png
http://accuratemolds.com/bullet_detail.php?bullet=40-200B-D.png

First one is a standard lube groove design and the second is tumble lube, both gas checked.
Hope this helps.

Hounddog
MGySgt
05-24-2013, 08:34 PM
The Lee 180 GR TC shoots great in a 40 S&W - and it is a 6 banger!
emorris
05-24-2013, 08:40 PM
NOE offers a 200 grain WFL mold, but it is not a gas check design. I have this mold and it looks really good. It casts a 180 grain hollow point or 200 grain FP boolit. So members here sells plain base gas checks that you could try on this boolit.
thomashoward
05-26-2013, 07:01 PM
Perfect.
Thank you
Intel6
05-31-2013, 12:49 PM
To get the real WFN bullet go to the originator, LBT.

I am a big 10mm nut and wanted to be able to make my own heavy GC WFN's for my 10's.

I got a 220 gr. WFN from LBT and have had great success with it in both my autos and my revolver.

The pic shows a 200 gr. bullet pulled from the DT ammo (not sure if it is the old design) and then a pic of my self cast bullet and then the last one is a 200 gr. TC from a Lyman mould that I have a pair of.
thomashoward
05-31-2013, 09:53 PM
Nice.
I just got some aluminum gas checks in 10 mm today. putting a gas check on a plain base bullet is new for me.
Do you make gas checks?
anyway I just picked up my G20 today. I have 500 cases.Next is stainless guide rod and a round wound spring of about 22lb.
On deck is a LWD 5.2 threaded barrel
I have 1K of Hornady 180 XTP's to play with as well. The fun never ends
Intel6
06-03-2013, 01:06 PM
Been wanting to try the PB aluminum GC's on some of my non GC bullets.

I don't make GC's, the LBT moulds use .41 cal GC's. They get swaged down some but that is the way Veral designed them.

I also have been making .40 JHPS & JSP's using fired 9mm brass so I go that route except for the real heavy bullets.

Neal in AZ