6 Cavity in 312-155 for AK. ?

[PDshooter]

I have a 2 cavity from Lee now,and the C/B 312-155? works great in my AK,and SKS. Its ok, but it takes forever to make a pile of C/B....Who makes a 4,5,or 6 cavity mold. I'm using straight W/W and 23GR IMR4895, or 15.5grs of 2400. The days are long gone at .07cents for 7.62X39 :cry::cry:
What mold do like for your AK, SKS and type of C/B........Thanks

[338RemUltraMag]

Basically you can look on NOE's site (arent any) or you can go to Tom at accurate molds, he can cut a 5 cav for about 150 and will help you design the boolit, send him in a sample and I am sure he will copy it.

Josh

[2wheelDuke]

I was considering making an interest thread for a group buy mold for a clone of that CE Harris boolit in a brass 4 cav.

NOE has a similar design that I might look into as well.

[Larry Gibson]

Get 2 more 2 cavity moulds and work them in tandum. Almost as fast as a 6 cavity mould.

Larry Gibson

[PDshooter]

I would be up for a group buy ![smilie=s:

[rmatchell]

+1 on a group buy. I havent been able to get the mold yet but picked up a few hundred cast and had decent luck out of my 308

[historicfirearms]

The NOE 155 is a great performer in my AKs and sks.