AJAX22
04-16-2013, 11:54 PM
I had a crazy Idea I want to give a try..... may be a bad idea, but i have to see what it does (literally something that came to me in a dream as nutty as that sounds).
I want to get some molds I can use to cast dead soft 300 (or possibly a little more) grain bullets for my 41 magnum ruger superblackhawk. (4 5/8 barrel)
I think if I get the molds made to accommodate gas checks I may be able to get something with interesting kinnetic energy transfer worked up without having too much leading ..
So.... how do I make this happen?
I have a little time, the 41 mag is taking a bit of work to track down all the parts, then I have to finish the engraving, parkerize her, and make a holster before she is ready for phase one testing .... (and then I have to track down or fabricate a brass gripframe, brass ejector housing, and brass rear sight for phase two)
I don't plan on shooting a particularly high volume, would prefer to get a single cavity (or dual cavity) mold made, and I also need a good smaller volume melting/pouring setup, sizing setup, loading setup etc....
I want to make this happen bad enough that I'm willing to make the investent on whatever I need to make the dream into a reality.
Can anyone help point me in the right direction?
Here is the 41 Mag as she currently sits
67738
I want to get some molds I can use to cast dead soft 300 (or possibly a little more) grain bullets for my 41 magnum ruger superblackhawk. (4 5/8 barrel)
I think if I get the molds made to accommodate gas checks I may be able to get something with interesting kinnetic energy transfer worked up without having too much leading ..
So.... how do I make this happen?
I have a little time, the 41 mag is taking a bit of work to track down all the parts, then I have to finish the engraving, parkerize her, and make a holster before she is ready for phase one testing .... (and then I have to track down or fabricate a brass gripframe, brass ejector housing, and brass rear sight for phase two)
I don't plan on shooting a particularly high volume, would prefer to get a single cavity (or dual cavity) mold made, and I also need a good smaller volume melting/pouring setup, sizing setup, loading setup etc....
I want to make this happen bad enough that I'm willing to make the investent on whatever I need to make the dream into a reality.
Can anyone help point me in the right direction?
Here is the 41 Mag as she currently sits
67738