IllinoisCoyoteHunter
04-13-2013, 10:53 PM
I would like to get a pneumatic derimming press set up. I have a 4" stroke air cylinder with a shaft that measures exactly 1.000"...the same as my Rockchucker Ram (or within a thou or two). So I plan on running the pneumatic cylinder shaft up through my press, but it is obviously too short. I was wondering if anyone could make me a 1.000" wide extension that measures 3.000" long.
The details: On the end of the ram on the pneumatic cylinder it is reduced down to a 3/4" - 16tpi male threaded section that measures 1.0625" in length. This is what my 3.000" "adapter" would screw on to.
On the base punch end I would like it tapped to the following specs : 1/2-20tpi and 1.250" deep
Here is a picture. I am not an artist so don't bust my chops!!! :shock:
67378
The details: On the end of the ram on the pneumatic cylinder it is reduced down to a 3/4" - 16tpi male threaded section that measures 1.0625" in length. This is what my 3.000" "adapter" would screw on to.
On the base punch end I would like it tapped to the following specs : 1/2-20tpi and 1.250" deep
Here is a picture. I am not an artist so don't bust my chops!!! :shock:
67378