scrapcan
08-28-2007, 03:27 PM
I thought the link to Marv Klotz's webpage would be a good one for those of you here that are looking for info on bulding things. lots of good info on the site. some info on 3-wire thread pitch, change gears, dividing head, drill bit sizes, etc...
Just hought I woul dpass it along. Most of the software is dos based, but will still work for the intended purposes.
Here is the link
http://www.myvirtualnetwork.com/mklotz/
one intersting tool is the ogive calculator to help you cut a particular ogive on a lathe, it is in the list.
Just hought I woul dpass it along. Most of the software is dos based, but will still work for the intended purposes.
Here is the link
http://www.myvirtualnetwork.com/mklotz/
one intersting tool is the ogive calculator to help you cut a particular ogive on a lathe, it is in the list.