win 94 failed to extract

[primersp]

hello
i have an WIN 94 top eject in 30/30 it's failed to extract,with manufactured or reloading cartridges
change the extractor ,same issue ,
the riffle feeds and cycles good
somebody have an idea
thanks

[starnbar]

You are saying it will chamber and remove the cartridge from the chamber just not ejecting correct? If so take a look and see if your ejector is loose or broken.

[primersp]

the exctrator grabs the case but and remove the case on about 1/2 inch and after jump off the rim, when the case is extract correctly ,it will eject .

[John Taylor]

Sounds like the extractor is not fitted right. Sometimes they do not drop down far enough to catch the rim. Just had one last week that was doing the same thing. I cleaned the groove in the top of the breach bolt and it still did not work, ended up filing on the bottom side of the extractor so it would drop down more.

[primersp]

thank i will try this ,the groove is clean ,filing the bottom of the extractor

[dominicfortune00]

Is there any roughness in the chamber which could cause a fired cartridge casing to be hard to extract?

[primersp]

no the cases come out clean ,the chamber is good ,i have try neck size or full size same problem