Had to pull some boolits

[Matt_G]

First time I ever had to pull a quantity of them.
What a pain.

Anyways, they were 41 mags.
I'm wondering if I should pull the decap pin out of the sizing die and size and expand them again, or do you think they will be good as is?

[engineer401]

Verify the case size with a case gauge or by measuring with a caliper. I would be surprised if the cases need resizing. You may need to flare the cases if the cartridges were crimped.

[USMC87]

I have done the same thing, I did'nt have to resize at all just as engineer401 said to flare the case mouth again.

[rocice]

I've had to re-size because of bullet setback after pulling bullets

[Matt_G]

Thanks for the advice guys.
I'll just re bell the mouths and go on my way.

[joehaberxxx]

I would resize to get the proper friction fit between case and bullet. I don't think that you are going to be working the brass case all that much to reduce the case life it will just be your time.