View Full Version : Beagling a Lee Six-cavity mold
JWFilips
03-03-2013, 12:33 PM
If one were to try to beagle a lee six cavity mold what would be the best placement of the alum tape strips? I would imagine the "side ends" and "bottom" but would a piece also go between each of the cavities?
runfiverun
03-03-2013, 02:31 PM
doubt you could keep a piece there.
if you can that would be best.
put the tape on to try and hold the mold halves as square as possible.
mold maker
03-03-2013, 03:29 PM
If only the ends and bottom are beagled you must be consistent with the handle pressure. Otherwise different sizes will result within each pour.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.