Removing Bevel From TL430-240-SWC and TL358-158-SWC Molds

[Southern Shooter]

I have the two LEE molds listed in the title above. How do I remove the bevel from these two molds?

Thanks

[Ben]

If you want it done right , send it to Buckshot.

[fishnbob]

I used a Dremel tool with a cutter to remove the bevel from one of the cavities of my Lee molds. I left the other beveled in case I wanted to use bevel base at a later date. So far, I haven't used it so I guess it is time to ream 'er out. You just have to be real careful and do it slowly. If you take out a little too much, you can correct it with a sizer. You may have to resize it twice if you leave it too full, so go slow.

[GRUMPA]

+1 on what Ben said