View Full Version : I need a favor from a Lyman 450 owner
buck1
07-29-2007, 01:48 PM
I need to know the inside dia. of the die retaining nut ( measured with calipers) .
OOPS! also the distance from the top of the nut to the top of the die.
Thanks a bunch!! Buck
Jon K
07-29-2007, 03:00 PM
Hey Buck,
Lost yours, did you?
Here is what you're looking for:
Thd OD= 13/16"-32tpi
OAL= .3085"
ID=.725"
Bore depth=.206"
Cap ID=.625"
Cap head - die=.1025
* Top of the nut has a 30* chamfer/.050" deep
That should give you sizes to make new one.
Jon
:castmine:
buck1
07-29-2007, 03:07 PM
Thank you very much buddy!.......Buck
Here is what you're looking for:
Thd OD= 13/16"-32tpi
OAL= .3085"
ID=.725"
Bore depth=.206"
Cap ID=.625"
Cap head - die=.1025
Jon K
07-29-2007, 03:14 PM
Buck,
BTW,
I just checked Lyman website:
http://www.lymanproducts.com/lymanproducts/index.htm
Replacement Parts 4500/450 - (16) Sizing Die Retaining Nut
$1.00
Jon
gray wolf
07-29-2007, 06:55 PM
That's no fun---------- Make it.
singleshotbuff
07-30-2007, 12:51 AM
Buck,
I have one from a 450 that died, if you want it.
I also have other parts from a 450, if you need other spares.
SSB
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.