HP Mold?

[GLynn41]

Hay guys is there any one who can /will/ does convert like say my single cavity 410459 into a hollow point mold--the mold was nib when i got it and it cast fine although a bit slow-- any one know? thanks:roll:

[Scrounger]

Buckshot has done it for several people here. I don't know what he might charge for it...

[beagle]

That's a darn good conversion. I did one cavity of a DC mould with a .140" diameter pin and had it opened up .413".

Shoots great in my .41 Blackhawk.

Buckshot will fix you up./beagle

[dakotashooter2]

I'll vouch for buckshot. He did a .41 cal RCBS for me and I love it. $25-$30 plus shipping if I recall. Too cheap and well worth it.

[GLynn41]

i'd recon I need to pm Buckshot then --thanks

[Glen]

The 410459 HP is an excellent bullet for hunting deer. I shot a mulie doe through the heart with one a few years ago and she travelled less than 20 yards after the shot.

[GLynn41]

I remember reading the article although I do not remember were -- and it peaked my interest

[GLL]

Buckshot's craftsmanship is OUTSTANDING ! :) :)

Jerry

http://www.fototime.com/FC1FBCABD1CE997/standard.jpg