6mm250
02-09-2013, 11:12 AM
I'm new at this here boolit casting.
I have smelted down a bunch of the good old timey clip on wheel weights & got me some nice clean ingots (several hundred lbs)
I also have some dead soft lead (several hundred lbs)
Plus I have a few lbs of pewter.
I want to make plinking boolits for 38/357 , 41 & 44 mag , 45 , etc.
Velocities of my loads will top out in the 1000-1100 fps range.
Bearing in mind that the WW metal will be the hardest to replace ;
What would be a good alloy that I can make out of the material that I have on hand ?
Thanks
Mike
I have smelted down a bunch of the good old timey clip on wheel weights & got me some nice clean ingots (several hundred lbs)
I also have some dead soft lead (several hundred lbs)
Plus I have a few lbs of pewter.
I want to make plinking boolits for 38/357 , 41 & 44 mag , 45 , etc.
Velocities of my loads will top out in the 1000-1100 fps range.
Bearing in mind that the WW metal will be the hardest to replace ;
What would be a good alloy that I can make out of the material that I have on hand ?
Thanks
Mike