View Full Version : I am in need of a mold recomendation
milsurpaddict
01-13-2013, 02:47 PM
Hello
I am looking for any suggestions of molds for my 1895 Chilean Mauser. I have done a lot of research but all the recommendations had more negatives than positives.
Thanks in advance
Milsurpaddict
I think you'd be wise to measure your throat and bore .
Hard for us to give a recommendation on something as general as you've offered at this point in time.
milsurpaddict
01-13-2013, 03:56 PM
Fair enough. I will do that and get back to you.
Thanks
MtGun44
01-14-2013, 11:37 PM
Many 7mms are seriously oversized, this can be a huge issue. Mine does very well
with 175 RN Hornady jbullets. So far, I have not tried boolits it that particular rifle.
Bill
milsurpaddict
01-15-2013, 12:44 PM
Hello
I slugged the bore it slugged out at .297. I am going to try MOLD DC C285-130-R. I know it is much smaller but if I can get the mold to drop oversize and not size it. If anyone has another recommendation I would love to hear it.
THanks
runfiverun
01-15-2013, 02:37 PM
297.???
you'll maybe,maybe get 287 from that mold with lino-type.
you'd have to wrap paper around it to get close to 297.
MtGun44
01-15-2013, 10:38 PM
I hope it is .287, which is a normal, fairly oversized 7mm Mauser bore diam.
Bill
PS Paul
01-15-2013, 10:44 PM
http://castboolits.gunloads.com/showthread.php?171200-Mould-for-a-7mm-Chileno-Mauser-1895&highlight=mold+chileno+mauser The attached thread has some good info, especially the recommendation from Larry Gibson, who has steered me correctly in two cases with my old '95 Chileno and '96 Swede. Hope that helps, man!
Paul
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.