Boolet recommendation for 375 Ruger?

[Elkins45]

Unless I talk myself out of it before midnight (the sale ends 12/31), I'm going to order one of the Ruger 375 laminated stainless left handed rifles that Davidson's has on sale. What's a good boolet for 375 Ruger? I'm assuming the same boolet that performs well in 375 H&H, but I don't know what that boolet is either.

TIA for any advice, and happy 2013!

[Bullshop]

The custom Bullshop 375/375 has worked very well with full power loads, 2400 fps in the 375 Ruger.
This is a 375 cal 375gn LFN-GC design.
It works well in the H&H and Whelen as well.

[Elkins45]

Wow, this thread sure didn't generate a whole lot of response!

I should clarify that I was asking about a mold to make them for myself.

[Larry Gibson]

377449 works for me in my 375 H&H M70 for practice nd hunting at 2150 - 2200 fps and for small game at 1850 fps. No reason to doubt it wouldn't do as well in the 375 Ruger.

Larry Gibson

[Bullshop]

Oh OK I have one from NEI that drops about a 320gn RNGC that I like as well. I have not used this one in the Ruger cartridge but have used extensively in the H&H cartridge. Like Larry said what is good in one should be good in the other as well.

[.22-10-45]

Hello, Elkins45. Do you happen to know the nominal groove dia. of the .375 Ruger? And you didn't say what use you intended..target or high velocity? If as I suppose, the groove is around .375..and you just wanted an accurate mild shooting load, any of the many plain-based bullets designed for the .38-55 should work well.

[375RUGER]

Well, did you get it?

I'm waiting for this one to be made.
http://castboolits.gunloads.com/showthread.php?157237-MiHec-375-H-amp-H-HP-GC-Boolit-2-or-4-Cavity-Brass-Cramer-or-Solid

[Elkins45]

Well, I bought it. I'm going to pick it up on Monday. I don't have any dies or brass so until they come in I guess it's just a shiny club.

[RobS]

Well, did you get it?

I'm waiting for this one to be made.
http://castboolits.gunloads.com/showthread.php?157237-MiHec-375-H-amp-H-HP-GC-Boolit-2-or-4-Cavity-Brass-Cramer-or-Solid

This one is good.....I have a two cavity that was made up (one hp'd and the other cavity solid) back when BRP Molds was in business. The Lyman 375449 is a decent design too and shot nearly as well as the BRP 378275 design.

[High Desert Hunter]

http://www.accuratemolds.com/bullet_detail.php?bullet=38-275H-D.png

I am waiting on my RH Laminate 375 Ruger Alaskan with the 23" barrel to show up. I'm thinking this is the mold I am going to try. Hope to hear if you had any luck with your setup.

[williamwaco]

Lyman 375449 and the Lee 379-250 work very nicely.

[btroj]

I got a 265D form Accurate for my 375. Shoots very well so far.