Anyone still converting moulds to cast hollowpoints?

[David LaPell]

Does anyone here still convert moulds to be able to make hollowpoints? I have not seen Buckshot for some time here and I was wondering if there was anyone that was still converting moulds for SWC or even wadcutters to make hollowpoints.

[GP100man]

Shoot Buckshot a PM , I like his style of HP pins more traditional.
Most HP from other machinists leave the noses kinda tender to handle with sizing/seating.

GP

[David LaPell]

Ok,

I found him and will shoot him an email.

[MtGun44]

Buckshot does beautiful work for the conventional Lyman pin style. Erik at Hollowpoint Services
does a wonderful job with Cramer pins or his own design plate type HP conversion.

Bill

[HARRYMPOPE]

Erik does both Lyman and Cramer styles.I can recommend his service highly.

[Texasflyboy]

Yes, moulds are still being converted.

I have several in the pipleline, including a 10 cavity Hensley & Gibbs #51. Still tweaking the design, but that's going to be something to see when its done.

[Bad Water Bill]

Will we get to see pictures of the finished product?[smilie=s:

[Ohio Rusty]

Buckshot has done 3 moulds for me and every mould is A+++.
Ohio Rusty ><>

[Texasflyboy]

Will we get to see pictures of the finished product?[smilie=s:

Of course! I usually post the results of a conversion a few days after I receive it.