Del-Ray
11-22-2012, 05:47 PM
I have some new Lapua brass for 6.5 grendle. I didn't like how some primers seated so I go out my decapper... The flash holes were very small. So small that after popping 2 primers out, the pin on my decapper came loose and lodged in the flash hole!
Any special tool for these small holes, and this is my first Lapua brass in Grendle. Is this a mistake, or are they all small holes like this?
Thanks.
Any special tool for these small holes, and this is my first Lapua brass in Grendle. Is this a mistake, or are they all small holes like this?
Thanks.