help with mold identy

[rmatchell]

I picked up another 3 molds today for 50 bucks although they were a lil rough.

I got a lyman 358477 with some surface rust, a lyman 475gr 12 gauge slug mold, and another that ill need some help with the identy I know its a ideal but not sure of much else everything else was ground off and had .36 with sharpy on the side.

[cbrick]

At the bottom of this page is a banner for Castpics.

Castics is one of the best cast bullet info sites on the web and has a huge amount of info on Ideal and Lyman molds. The info your looking for is almost certain to be there.

Rick

[rmatchell]

Here are a few pics. For 8 bucks i jumped for it.



http://castboolits.gunloads.com/imagehosting/thum_2467650a68621911d2.jpg (http://castboolits.gunloads.com/vbimghost.php?do=displayimg&imgid=7472)http://castboolits.gunloads.com/imagehosting/thum_2467650a68621b2628.jpg (http://castboolits.gunloads.com/vbimghost.php?do=displayimg&imgid=7473)http://castboolits.gunloads.com/imagehosting/thum_2467650a68621c3e54.jpg (http://castboolits.gunloads.com/vbimghost.php?do=displayimg&imgid=7474)

[rmatchell]

I cleaned it up and cast a few up the base a lil rough but not to bad. From the weight and sized cast it looks to me an Ideal 358250. Also I noticed that I already had a 358477 but after casting some I noticed that the nose profile is different one is square and one is rounded.

[Jason30-30]

Looks like the 358311 to me

[HARRYMPOPE]

I am sure it is the 358250 also.The reason its beat up is because if its like my 358250 with its square lube grooves it sticks in the mold like its glued in!
it shoots pretty good for me.