TCTex
11-01-2012, 10:58 PM
I want to shoot the 358009 in my 26in Encore barrel chambered in 357 Herrett.
In this picture I have the 358009 set .02 off the lands. Yes, the chamber is cut deep, LOL
http://www.handgunhunt.com/photopost/data/545/photo_12_2.JPG
Also, next to the 358009 is a 200gr FTX bullet at ruffly where is should be loaded for "book" loads.
The difference in case is ruffly .25 tenths. The biggest issue I have is just starting load data just because this titan is 270gr (the hollow point version) and I don't even know where to start. The heaviest bullet I have loading data for is a 200gr.
I did call Hodgdon today... ya... that was a bad experience... I actually got chewed out for even thinking up this idea.
Any thoughts, ideas, or recommendations?
Thanks
Duane
ps, yes I need to trim my brass. LOL. I didn't even notice it until after I took the picture otherwise I would have found two pieces closer in lenght...[smilie=l:
In this picture I have the 358009 set .02 off the lands. Yes, the chamber is cut deep, LOL
http://www.handgunhunt.com/photopost/data/545/photo_12_2.JPG
Also, next to the 358009 is a 200gr FTX bullet at ruffly where is should be loaded for "book" loads.
The difference in case is ruffly .25 tenths. The biggest issue I have is just starting load data just because this titan is 270gr (the hollow point version) and I don't even know where to start. The heaviest bullet I have loading data for is a 200gr.
I did call Hodgdon today... ya... that was a bad experience... I actually got chewed out for even thinking up this idea.
Any thoughts, ideas, or recommendations?
Thanks
Duane
ps, yes I need to trim my brass. LOL. I didn't even notice it until after I took the picture otherwise I would have found two pieces closer in lenght...[smilie=l: