Need dimensions for MEC part.

[littlejack]

Hey fellas.
I bought a MEC 600 reloader at St. Vinnies a while back. It did not have the priming spring or priming pad.
I made a spring, but still need the pad. This is the thick metal washer that sets on top of the spring, that holds the primer in place.
Now that I have my lathe, I figured I would just turn one for myself.
Can someone post me the dimensions of the piece? I would be much abliged. I need the thickness, the outside diameter, and the inside diameter of the hole for the primer. This is for a 12 guage.
Thank you.
Jack

[kullas]

od .935 id .346 thick .375

[ovendoctor]

or just contact Mayville engineering and they will sen ya the correct parts;-)

Doc.

[kullas]

But sometimes there is just a special feeling ya get when ya can make it yourself :)

[littlejack]

Thank you gentlemen for your responses.
kullas for the dimentions, and the comment about making it ourselves.
I come from a long line of metal fabricators and welders. I myself was in the metal fabrication
trade for 37 years.
My motto is; "If we cant buy it, we can make it. If we can't make it, we don't need it"
ovendoctor, I knew someone was going to say what you said. Thank you for your reply.
Jack

[kullas]

there is a small chamfer on the id here is a pic

http://i1265.photobucket.com/albums/jj516/kullas/2012-10-30_18-51-52_687.jpg

[ovendoctor]

But sometimes there is just a special feeling ya get when ya can make it yourself :)

yup I understand

I get the same feeling wen I make flat washers :bigsmyl2::kidding:

Doc.

[littlejack]

Yes sir, thanks for the picture.
Jack