Q

[jakharath]

Howdy guys! I'm stumped on what these are. Any of y'all have an idea?

1)
https://lh5.googleusercontent.com/-xJ6S_zKVlyU/UEQRhyphrVI/AAAAAAAACCg/STt0nGhYh5I/s512/20120902_202935.jpg


2)
https://lh5.googleusercontent.com/-_pKXXHM5-8s/UEQRh3cRyKI/AAAAAAAACCc/5Bp5mffv-TQ/s512/20120902_202950.jpg


3)
https://lh4.googleusercontent.com/-hMMp1wfyZVI/UEQRhwFs-eI/AAAAAAAACBw/h6DVQfJwSw4/s512/20120902_203001.jpg

4) Hammer from something. It's bigger than a 1911 hammer.
https://lh6.googleusercontent.com/-yYA8dLjGbp0/UEQRivWPfbI/AAAAAAAACCA/SYpwUIKCyOg/s512/20120902_203022.jpg

5) Magazine follower?
https://lh6.googleusercontent.com/-OteXvKTnqb4/UEQRiyjWrxI/AAAAAAAACCM/dmLHujhsD8M/s512/20120902_203048.jpg

6) This is TINY:
https://lh6.googleusercontent.com/-wRNxFo4eAgE/UEQRi13muYI/AAAAAAAACCI/qDtDyj563e8/s312/20120902_203114.jpg


Thanks!

[nicholst55]

The last item looks like a sear depressor for a Colt Gold Cup. It is spring loaded by a small spring in the sear, and fits in next to the sear. The idea was to allow for greater pressure on the sear so that you could safely have a lighter trigger pull on a target gun. Nobody uses them any more that I know of.

[fecmech]

Top one is a recoil buffer I believe for a 1911, or maybe the Dwyer Group Gripper. It was designed I think to position the barrel the same for each shot. Not real sure though.

[MtGun44]

1) 1911 short gun (shorter than Officers ACP) recoil assy - maybe Paraord
2) full sized 1911 recoil spring guide, needs a spring plug with a hole (prob. aftermarket)
3) not sure
4) 1911 hammer with spring strut cut off
5) not sure
6) Colt Gold Cup sear depressor

[375RUGER]

3) reverse plug for use with bull barrel

[runfiverun]

5 looks more like a floor plate than a follower.

[Blammer]

#1 looks like it'd go on a Kimber ULTRA CARRY model, 3" 45ACP barrel