NZSarge
08-03-2012, 09:12 PM
Hi, I have cast heaps of slugs from the 1oz and 7/8 molds. One of the molds was used when I bought it and not long after the bottom pyramid came away from the lower base...cheap Ali rivet had popped.
I know..dont bash them..but I dont..just tap or persuade the slugs off sometimes from the main bolt hinge.
Now the other has the same issue.
I drilled and tapped a PK screw into both but when they heat up the pyramid inner mold comes away again on both.
Is there a HI Temp glue I should use to keep the PK screw in..loctite?
I emailed Lee twice, to try and buy 2 more bottom plates with the inner mold part only, but rudely they wont respond. Only the " We'll get back within 48 hours bit":(
Maybe they don't rate business down under in the colonies..)..still rude but.
Any ideas to re-screw these plates and mold bits appreciated.
Thanks heaps..b safe..Sarge
I know..dont bash them..but I dont..just tap or persuade the slugs off sometimes from the main bolt hinge.
Now the other has the same issue.
I drilled and tapped a PK screw into both but when they heat up the pyramid inner mold comes away again on both.
Is there a HI Temp glue I should use to keep the PK screw in..loctite?
I emailed Lee twice, to try and buy 2 more bottom plates with the inner mold part only, but rudely they wont respond. Only the " We'll get back within 48 hours bit":(
Maybe they don't rate business down under in the colonies..)..still rude but.
Any ideas to re-screw these plates and mold bits appreciated.
Thanks heaps..b safe..Sarge