View Full Version : Rolling block firing pin?
I have looked almost every where to get a firing pin for a Remington rolling block #1 model with the rotary extractor. Have any ideas Thanks beng
Ed in North Texas
07-20-2012, 03:48 PM
Have you sent an e-Mail to Ken WomacK? kgwebay@wildblue.net or info@rollingblockparts.com
Is the retainer cutout on top or bottom on these? I got a new firing pin for my NY State model from Wisner's (original was long enough to scare me with the indentation - apparently it was the original FP made for the early inside primed .50-70 cartridges.
Anyway Wisner's makes new ones, both types plus the #5 7mm small tip FP.
Hope that helps.
Ed
enfield
07-20-2012, 05:45 PM
I have a lathe so that makes it a whole bunch easier[smilie=s: but I think a 1/4 " grade 8 bolt and a file and drill and you to could whip one up. I have made a couple with pieces of bolt and they have fired many a shot.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.