Casting Bench

[Swampman]

I built this today. All the wood was recycled from scrap and the nails came from the trash. Completely free.
http://i32.photobucket.com/albums/d34/Woodsman1956/Reloading/100_1337.jpg

[VHoward]

Looks good. Hopefully, it's attached to the wall. Wouldn't want that to tip over on you. Could be very bad.

[Swampman]

It's anchored to a stud.

[geargnasher]

Awesome. Change out that turbo tumbler for a hotplate and mould oven, pop out a folding table for air cooling or a quench bucket and you're good to go! I love free stuff.

Gear

[500MAG]

Hey Swampman, I like the setup but where do you release the castings?

[bobthenailer]

GEE i use every bit of a 8 foot bench for my casting operation

[Buckeye509]

Organization is key.

[1bluehorse]

I like it...compact, doesn't take up much room and you have all you need..and it was FREE...I used to have a pot like that...

[alamogunr]

I couldn't operate with so little room to spread out. I made a cover for my table saw and cast on it.

[Idaho Sharpshooter]

I made mine out of a quarter-sheet of 3/4" plywood, good on one side and framed it in 2x4's.
It's on 2" wheels, and the height was set to fit me in a metal folding chair.

[WILCO]

It's anchored to a stud.

That's what she said! :holysheep :hijack: :kidding::happy dance::2 drunk buddies::guntootsmiley::target_smiley:[smilie=l:.................................but really, the bench looks good. I like it.