41mag
05-22-2012, 08:49 PM
I didn't want to hijack the other fellows post, but I have some similar "type" material, which was said to be Lino. I also have some small blocks with letters and other typical print symbols on them which quite possibly might be Mono. I'm new to the "Type" material and in looking at various references, it can be either one or the other.
I want to simply melt it all up and pour it into the small SS condiment cups for later, is there a best temp to run the pot at to avoid overheating it? (I am using a Lee 4-20 with a PID controller on it.) I just was wandering if there was a specific temp range that folks use.
This is my first go round with any of the type material. I have purchased some more for future use on range lead to bring it up to a more suitable allow for my uses.
Any info would be appreciated.
Thanks,
I want to simply melt it all up and pour it into the small SS condiment cups for later, is there a best temp to run the pot at to avoid overheating it? (I am using a Lee 4-20 with a PID controller on it.) I just was wandering if there was a specific temp range that folks use.
This is my first go round with any of the type material. I have purchased some more for future use on range lead to bring it up to a more suitable allow for my uses.
Any info would be appreciated.
Thanks,