Swage Die Plans

[Hellorian]

I am just finishing up a press and was thinking about trying my hand at making my own dies. Does anyone have a design/plans for something that I could look at?

Any would do for reference. I am planning on at least a set for my 17Rem and 300Savage. PM me or post - I know quite a few others who have been looking as well.

Thanks
Hellorian

[alfloyd]

If you look at Corbins site, you will find cut-away drawings of their dies. You will need to make your own diminsions to make the cal of bullet you want to make.

Look here:
http://www.corbins.com/swaging.htm

This is about as close as you are going to find for a set of prints, as far as I know.

Their site gives a lot of info about diminsions needed for what cal you want to make.

Hope this helps
Lafaun

[Hellorian]

Every little bit helps, I appreciate it.