View Full Version : Looking for a source of copper disk stampings for jackets
Tokarev
05-01-2012, 02:58 PM
Does anybody know a source that can sell me a few 1000s of disk stampings?
The 1st order will be for 1.2-1.3" diameter 0.01" thick (that should be 28 gauge sheets although I am not 100% of the gauge).
Alternatively, I would look into ordering a ribbon of about 1.5" wide and and 100' long.
frank martinez
05-01-2012, 04:17 PM
Call Corbin. While I was there they were making discs to make jackets to test their dies. I believe he had boxes of the flat copper and cold probably help out.
Frank
Tokarev
06-27-2012, 05:02 PM
The whole point is to avoid calling Corbin. They charge arm and a leg for their products, and I don't blame them because they have a right to make a living. However the copper disks are not necessarily supposed to be expensive.
Red River Rick
06-28-2012, 02:49 PM
Those are awfully large blanks. What diameter jackets are you intending to draw from a blank that large?
RRR
Tokarev
06-28-2012, 03:02 PM
58 cal
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.