Nee d hex sizes for LYman, RCBS Sizers

[44 WCF]

I have sold my 4 Lyman 450's and RCBS LAM-2. I have left over box end wrenches that I cut off to use to change dies and to use on the hex on the LAM-2 Lube reservoice cover. Only problem is I have wrenches but don't know which goes to which so I can post.

I'm pretty sure the die hex nut on the LAM-2 is 15/16", but I need to know corect hex size for the LYman 450 die retaining nut and the very large hex nut on the LAM-2 luber reservoir cover.

Thanks for any input

44 WCF

[theperfessor]

The die retaining nut on the 450 and 4500 is 7/8" across the flats. RCBS uses 15/16".

[44 WCF]

Well, I have neither 7/8 or 15/16, these are larger size, 1", 1-1/8".
cant figure out what i wold have chopped these box wrenches for. I welded a tab but is too short to reliably start a nut straight.....hmmmm,,,,,,,,,,what is the next to go after the memory???????

[alfloyd]

what is the next to go after the memory???????

Memory is the 2nd thing to go.

I forgot what the first one is. :(

Lafaun