Eric H
04-16-2012, 09:11 AM
My 9mm and 40 sw boolits were spot on the money as cast . My .452 lee two mold cavity the one with the micro grooves . My boolits were fine at the lube grooves then expanded to .455. right ware it started going to the truncated cone. My bullets also weighed about 5-8 grains heavy. Is it me or the mold or both? I assumed it is me. My aloy is range scrap withsome solder thrown in.
I did take my 40 sw and 9mm as cast boolits out ant shot some. I lubed some with Xlox and some with JPW Both worked good with no leading. I will get some mineral spirits to mix my next lube.
so Once I get my 45 problem squared away. I will be off to further this Horibly adictive Habit of Mine.
thanks Eric.
I did take my 40 sw and 9mm as cast boolits out ant shot some. I lubed some with Xlox and some with JPW Both worked good with no leading. I will get some mineral spirits to mix my next lube.
so Once I get my 45 problem squared away. I will be off to further this Horibly adictive Habit of Mine.
thanks Eric.