walkswithsticks
04-02-2012, 04:02 PM
I purchased a rifle from a fellow shooter at the local range. It was built on a Falling Block Works Model J action and an unknown barrel. The gunsmith who cut the chamber is now deceased. The rifle is showing symptoms that the chamber may have been cut crooked to the bore.
Our only solution may be to cut off a couple of inches, rethread, and rechamber. Unfortunately, there isn't anyone local.
I cannot find the list of vendor/sponsors here. Where is it? Any recommendations on who to get to do this work?
Our only solution may be to cut off a couple of inches, rethread, and rechamber. Unfortunately, there isn't anyone local.
I cannot find the list of vendor/sponsors here. Where is it? Any recommendations on who to get to do this work?