BigRix
04-01-2012, 11:13 PM
Picked up a new to me Ideal 452460 two cavity and so far I'm very happy with the boolits that are dropping from it.
The problem is my .452 sizer die for my Lyman 450 only has holes at one level and I can't for the life of me get any lube in the top groove.
http://i576.photobucket.com/albums/ss208/BigRix/Casting/f3343855.jpg
I know you can run .38 wadcutters with only one groove lubed but I don't think it would work with these small grooves.
I'm considering running them through the 450 then tumble lubing them.
Should I look for a different die with multiple holes?
Any thoughts?
The problem is my .452 sizer die for my Lyman 450 only has holes at one level and I can't for the life of me get any lube in the top groove.
http://i576.photobucket.com/albums/ss208/BigRix/Casting/f3343855.jpg
I know you can run .38 wadcutters with only one groove lubed but I don't think it would work with these small grooves.
I'm considering running them through the 450 then tumble lubing them.
Should I look for a different die with multiple holes?
Any thoughts?