wmitty
03-08-2012, 10:48 PM
I wanted to run this by you gentlemen before proceeding, since there is nothing new under the sun. I intend to try the 8 mm Max boolet reduced to .311" in a 2 groove 03-A3 for use as a short range hog load. I've made up some of these by running them thru a .321" Lee push thru after lubing with Carnuba Red. I then sized them to .311" by pushing them base first thru another Lee ( to prevent gas check distortion). Checked and lubed the boolets weigh 249 gr. and are 1.305" in length. My question is in regards to powder/ charge wt. Lyman shows 25 gr. Re-7 as a starting load for the 210 gr. 311284 @ 22200 c.u.p.
Would a starting charge wt. of 20 gr. Re-7 be a reasonable place to start with the heavier boolet? I realize I might be walking into uncharted territory here. Any opinions would be appreciated.
2
Would a starting charge wt. of 20 gr. Re-7 be a reasonable place to start with the heavier boolet? I realize I might be walking into uncharted territory here. Any opinions would be appreciated.
2