Original Lee Cutter

[Josh Smith]

Hi Folks,

This is not my auction. I'd never seen an original cutter before, though, so I looked one up.

It's over in England but will ship here. I'm posting this in case it's of interest to anyone.

http://i.ebayimg.com/t/LEE-Bullet-Lube-35-Cutter-New-Old-Stock-/00/s/MTAyNFg1Njc=/$(KGrHqF,!jkE8F-NPZZdBPT9QLI-j!~~60_58.JPG

Package is rough, but it's stated it's never been opened.

http://www.ebay.com/itm/230755029904

Hope this helps someone!

Regards,

Josh

[stubshaft]

I still have a couple of those with the original sizing dies that used a mallet to push the boolit through.

[6.5 mike]

Still have mine for .357, did use up the lube though.

[DLCTEX]

I have one for 44 cal., but don't cast 44. May some day though. I wondered if it originally came with some method of pushing the boolits out?

[stubshaft]

This is my first sizer circa 1969? I used it after casting boolits using a tin can on the stove and a modified spoon for a ladle. The mold was a Lee 30-150F single cavity, which still casts good boolits to this day.