curious

[ubetcha]

I was wondering about something but haven't had the time to check it out.If one were to beagle a mold,say for instance 44mag and it cast a bullet out of round.Say 0.430 at the parting line and 0.432 opposite the parting line,and it was pushed through a 0.431 sizing die,would the lead from the larger diameter flow or squeeze to the smaller diameter and make a 0.431 size bullet?

[462]

Nope. But it will fill any crimp or lube grooves, as it is moved down, or up, depending on the type of lube/sizer.

[stubshaft]

Yup, it would just scrub off the higher portion.