View Full Version : 8mm plain base
rollingblock
02-29-2012, 03:26 PM
I have an 8mmplain base mold. I was wondering about useing 338 checks swaged onto the plain base. Has anyone tried this or something similar.
PatMarlin
02-29-2012, 09:59 PM
No need for that if you wanted to make your own checks.
I have a 32PB just what the Doc ordered.
rollingblock
03-02-2012, 08:13 PM
I'll pass on the check maker for the time being. I only have one plain based mold ( cbe200gr).
Blammer is going to chuck in a few 338 GC with my GC order so I'll keep you posted on the success or failure of the plan.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.