Why I love MP molds - 432256

[Iron Mike Golf]

Started working up some AA#7 and #9 loads. This boolit over 19.6 gr of 2400 is more or less my "reference load".

http://castboolits.gunloads.com/imagehosting/thum_169734f447ecf0018b.jpg (http://castboolits.gunloads.com/vbimghost.php?do=displayimg&imgid=4076)

The bottom 3 targets of the middle and whole right column are 19.6 gr 2400. The left column is 20.0 gr of AA #9. The top 2 of the middle column are 17.6 gr of AA #7. All groups are 5 rds, excep the bottom right. That's only 3 rds (ran out of boolits). The bottom center and right were rushed as it was 5 minutes before closing time. I also need to check for leading in the bore.

Shot info:

7.5 inch Redhawk Hunter, 2x Nikon Monarch scope
Range is 55 ft (I'll move outdoors when it warms up and dries out) off a rest
Target spots are 3/4 inch

[Lefty SRH]

Nice results, can you post a pic of the boolit?

[Dschuttig]

Hollow point or flat? I was thinking of ordering one of those is HP when the 6.8 bullet is done to save shipping. The 4 cav cramers are a dream come true, saves so much time.

[Iron Mike Golf]

Those are with the solid. I have a 4 cav cramer type in 45 SAA and a 2 cav in 44 RF. I'll get a pic up later today.

[Iron Mike Golf]

Here's a shot of the boolits:

http://castboolits.gunloads.com/imagehosting/thum_169734f451436ef915.jpg (http://castboolits.gunloads.com/vbimghost.php?do=displayimg&imgid=4078)

[MiHec]

I still have some of this molds. Both HP or solids.....

It is called HG#503.

If you want one, PM me.