nitro450exp
02-12-2012, 11:25 AM
Hello all.
The double rifle project is going well. 20ga 3" chambers.
See thread in here.
I have RMC brass that measures 3" long 2 types, one for ball and one for slugs.
The ball holds 195.5 grains H2O and the Slug brass holds 193.6 grains H20.
Primers are CCI 209 Magnum.
Bullets are 350 grain 0.625" hard cast ball.
and 450 grain Turbo hammerheads sized to 0.622".
and NEI mold that throws 0.622" 720 grain or 550 grain after hollow pointing with 3/8" drill.
I can play with seating depth and wads, but would like to try keeping the bullet as close to forcing cone as possible, and no wads if possible.
Trailboss sound like it has the density I am looking for.
The guy at Accurate said the the load density on 5744 is no good.
Anybody have any trailboss loads for brass cases ?
Thanks in advance.
The double rifle project is going well. 20ga 3" chambers.
See thread in here.
I have RMC brass that measures 3" long 2 types, one for ball and one for slugs.
The ball holds 195.5 grains H2O and the Slug brass holds 193.6 grains H20.
Primers are CCI 209 Magnum.
Bullets are 350 grain 0.625" hard cast ball.
and 450 grain Turbo hammerheads sized to 0.622".
and NEI mold that throws 0.622" 720 grain or 550 grain after hollow pointing with 3/8" drill.
I can play with seating depth and wads, but would like to try keeping the bullet as close to forcing cone as possible, and no wads if possible.
Trailboss sound like it has the density I am looking for.
The guy at Accurate said the the load density on 5744 is no good.
Anybody have any trailboss loads for brass cases ?
Thanks in advance.