Seating Gas Chex

[GT27]

Has anyone tried this yet,opinions? :cbpour:

http://www.youtube.com/watch?v=UZxd3GDb_DQ&context=C3c044f1ADOEgsToPDskJaup7aOF39C6yZ-989QLBc

[Ben]

I'd like to know the dia. of the g/c AFTER his crimping operation ?

If it is " sub .310 " that could be a problem.

Ben

[GT27]

[@joeatact Thank you! If you use this method, make sure you crimp them well and [measure the width of the gas check before you seat the bullet in a case. Because if [the check is too wide, it could flare your case to a point where it'll be too wide to [enter your gun's chamber. Don't ask how I know... Let's just say that I know. lol
[
[MrPrairieGunner 1 month ago

Ben, he evidently ran into that problem starting this as you see from the above copy from U-tube(his statement) above,I tried it with a 7.62x39 and it mic'ed .311,the same size that my Lee Mould casts at! The check is on there nice, and tight,after crimping it with the 7.62x39 factory crimping die...

[Ben]

May just be the way to go ?