beanflip
01-13-2012, 01:19 AM
I turned my rock chucker handle that had a ball on it in to a roller handle.
The cost about $2.
Here the list:
5/8-18 nut ...... 25 cents
a piece of 3/8 cold rolled rod .... maybe a $1
2 -- 3/8 washers .... maybe 20 cents
1 inch piece of wood dowel ... maybe 50 cents
I all ready had everything but the 5/8-18 nut.
Welded the cold rolled rod to the nut ( note rod is at an
angle). Let it cool down while drilling the 1 inch dowel.
Put a washer on then the wood dowel then the other washer
then welded the washer on.
It works great!!!
The cost about $2.
Here the list:
5/8-18 nut ...... 25 cents
a piece of 3/8 cold rolled rod .... maybe a $1
2 -- 3/8 washers .... maybe 20 cents
1 inch piece of wood dowel ... maybe 50 cents
I all ready had everything but the 5/8-18 nut.
Welded the cold rolled rod to the nut ( note rod is at an
angle). Let it cool down while drilling the 1 inch dowel.
Put a washer on then the wood dowel then the other washer
then welded the washer on.
It works great!!!