threedflyer
01-10-2012, 09:59 PM
To those not familiar.....I wanted to share some photos of a Pak-Tool which was the creation of W. H. (Bill) English here in the Seattle area some time back.
Actually this is a take-off of the Newton reloading tool. It seems that Mr. Newton neglected to get some of the patents secured so Mr. English went to work!
The photos show the complete kit as it came in it's green plastic tube, also includes the decapping rod (not shown in photo)
The kit included all that you see......very handy field tool to say the least!
I have two of these complete kits with the original instructions set up for 30-06.
I also have a few other sets of dies/fittings in other calibers including .38, 32-20, 257 Roberts, 7x57 and 45-70
Not exactly sure what I will do with these, but they are certainly interesting!
Tom
Actually this is a take-off of the Newton reloading tool. It seems that Mr. Newton neglected to get some of the patents secured so Mr. English went to work!
The photos show the complete kit as it came in it's green plastic tube, also includes the decapping rod (not shown in photo)
The kit included all that you see......very handy field tool to say the least!
I have two of these complete kits with the original instructions set up for 30-06.
I also have a few other sets of dies/fittings in other calibers including .38, 32-20, 257 Roberts, 7x57 and 45-70
Not exactly sure what I will do with these, but they are certainly interesting!
Tom