View Full Version : 32-20 Gas Check Size??
ohiochuck
12-31-2011, 03:38 PM
Question- which size gas checks for reloading cast boolits 32-20? .308 or 32 Cal-8mm Gas Checks??
Thanks!
Jim
Yance
12-31-2011, 03:39 PM
30 cal.
Hickory
12-31-2011, 03:40 PM
30 caliber gas checks are what is required.
30 cal is all I have used in my 32/20s. Hornady and Gators have done well in the past.
ohiochuck
12-31-2011, 04:18 PM
Thanks for the information, I will order the .30 cal Hornady gas checks.
Jim
Arceagle
01-03-2012, 10:58 PM
Will this hold true on a .327 federal mag too? Even if it is sized as much as .314 or .315?
Bret4207
01-04-2012, 08:18 AM
Yes. The GC shank should be sized for the GC, not the groove or bore. The only issue I think you run into is when the GC gets appreciably smaller than the groove you can get to a point that it doesn't work any more. If the GC is allowing gas cutting then you are wasting your money on the GC. That's a rare occurrence though.
Jon K
01-04-2012, 10:39 AM
Check the Sticky for GC size and measure your shank size.
http://www.castboolits.gunloads.com/showthread.php?t=17539
Jon
Arceagle
01-04-2012, 01:33 PM
Thanks for the info. I'm just getting ahead of myself, don't even have my mould yet. I need to make a big pot of coffee, sit down and read Stickies.
If I thought my UPS man and local post office staff didn't like me before - just wait till I start getting lead in the mail. Thanks!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.